Is it possible to connect one HWIC-4SHDSL with four CISCO878? How many dsl-groups are needed to make this configuration? (in Command Reference for dsl-group command only two possibilities are described: dsl-group 0 and dsl-group 1)
It is PHYSICALLY IMPOSSIBLE to insert any modules, whether it's a H/WIC or NM/E, because the 800 series family of routers is a completely-sealed model. Modular models (where you can add modules) start from the 1800 or 1900 and includes the 2800, 2900, 3800 and 3900 ISR.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...