Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

HWIC-4T1/E1 inter-op with HWIC-2CE1T1-PRI

Hello,

Kindly let me know if anybody have experience with HWIC-2CE1T1-PRI and HWIC-4T1/E1 interconnect end to end. it's possible to work or not. And what additional command required in order to used HWIC-2CE1T1-PRI full 32 channels.

1 REPLY
Hall of Fame Super Gold

Re: HWIC-4T1/E1 inter-op with HWIC-2CE1T1-PRI

Yes these can interconnect, however you can configure a maximum of one single channel-group on the HWIC-4T1/E1.

You can instead have a maximum of 31 channels on any type of channelized E1 interface, because timeslot 0 is reserved for synchronization and CAS signaling.

222
Views
0
Helpful
1
Replies
CreatePlease to create content