cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
462
Views
0
Helpful
4
Replies

I can't install the NPE-G2 on Cisco router 7206 VXR

kashalo84
Level 1
Level 1

i'm trying to install the NPE-G2 on Cisco Router 7206VXR but the keying post on the NPE-G2 stock in the end of the chassis.

Anybody have this problem before please help ASAP

4 Replies 4

Amit Singh
Cisco Employee
Cisco Employee

Could you please capture the router booting sequesnce and paste it here.

I can't start the router because I couldn't insert the NPE-G2 into the slot because the keying post as illustrated in the attachment file. And you know the NPE-G2 is the main controller of the router.

Hello Anas,

are trying to insert the NPE-G2 in place of the current NPE ?

Be aware that in same side of PAs there is the I/O controller

verify that the chassis is 7206VXR and not a C7206.

boot with the old NPE and issue

show c7200

and check the chassis type

Hope to help

Giuseppe

Hello Giuseppe

thank you so much for your help.

i notice that there is two NPE-G2 version one with keying post and one without and the chassis that i have don't support the new one and i think i should get the older version of NPE-G2 i don't think that i have another choice.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco