Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

I could not return to previous version on 2921

Hi,

I have a 2921 c2900-universalk9-mz.SPA.150-1.M3.bin , at the beginning was c2900-universalk9-mz.SPA.150-1.M2.bin. I have uck9 and ipbasek9 permanent license. Because of some problems with FXS card I had to change form M2 to M3.

When I try to return to the previuos version I could not do it, the router sent a message about security and went to rommon 1>  every time I try to reload it.

any reason about this issue??

I need to return to the previous version because the new one has a bug related with DND softkey

regards

4 REPLIES
Bronze

Re: I could not return to previous version on 2921

Can you post a 'dir flash:' and 'set' from ROMMON?

Also post the exact message you see regarding security

New Member

Re: I could not return to previous version on 2921

Hi Vijay,

Currently the router is operating and I can not try to get the info , I need to wait for finishing office hours.

I attach the dir flash: but not from ROMMON

thanks for your time

regards,

Bronze

Re: I could not return to previous version on 2921

Did you delete the M2 image from flash?

New Member

Re: I could not return to previous version on 2921

Hi,

I delete M2 image when I load M3.

I have a copy of M2 which I used when I tried to return to previous image.

regards

357
Views
0
Helpful
4
Replies