After pressing enter it should display a message that says something like this
***— SHUTDOWN in 0:10:00 —
I am not able to see the above message. It works with 1 mint, 5 mint, and 30 mint. Is there a way to configure this in order to see this message I really needed for my development. I need to increase the time up to 7 mint that gives the router to copy all of the TCL scripts into the Cisco flash
*** — SHUTDOWN in 0:07:00 —
Many Thanks for reading this message, your help will be appreciated
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...