I have 2 Arrowpoint CS-800 (cisco CSS 11800) They are both booting up fine but I can't telnet to them even with console port
I have these units looks like they are booting up fine but I can't communicate with them. I got setup pdf files and using the com port settings but I can't reach them. some times I don't get any response at all some times I get some ASCII characters. I used port settings :
Baud Rate - 9600
Data Bits - 8
Flow Control - none
Parity - none
Stop Bits -1
still no communications, I'm using regular blue console cable cisco uses. can anyone help?
Re: I have 2 Arrowpoint CS-800 (cisco CSS 11800) They are both b
You setting looks correct. Try changing the baud rate to 38400 and see if it helps. if that does not help try a different application i.e terra term or Secure CRT, etc... to access the devices and see what happens.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.