Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

I have a cisco router 2600 with one ethernet 0/0 only. I assigned the IP address 192.168.1.1/24 to it. There's no other etherne

I have a cisco router  2600 with one ethernet 0/0 only. I assigned the IP address192.168.1.1/24 to it. There's no other ethernet port. How can I telnet to this router?
Thanks

2 REPLIES
New Member

You can connect your pc

You can connect your pc/laptop to ethenet port 0/0 and assign IP address 192.168.1.2/24. After that, just telnet to 192.168.1.1.

Make sure to set up the vty lines to accept telnet as well as assign an enable secret via your console session.

Silver

well you have one interface

well you have one interface just assign the ip address to that interface and enable telnet on the router set the passwords and then connect the port with the switch .

  Then use can telnet using your network.

 

****** Do rate Helpful links***********

113
Views
15
Helpful
2
Replies