Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

I have a question that How PBR works?

Hi.

I wonder that the PBR How it works at CCO as following:

"If the packets do not match any route map statements, then all the set clauses are applied."

the pbr works step-by-step. for example

route-map korea 10

match access-group 10

set ip precedence 30

route-map korea 20

match access-group 20

set ip precedence 31

route-map korea 30

match access-group 30

set ip precedence 32

and then Implicited Denied ,because of route-map rules. Right?

If packet is no match route-map rule,then the packet is processed normal switching not process.

but above statement. if the packet do not match any route-map statments, then all the set clauses are applied.

I can't understand above statement. if the packet do not match any route-map statement, the packet is just normal

processing, but the statement at cco says all set are applied.. <- Wrong Statement?

if right , Let me understand about this.

Thank you in advance

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Silver

Re: I have a question that How PBR works?

Sung

The statement that you quote does not seem correct to me. I wonder if it is discussing some specific circumstance or perhaps is just an error in the documentation. A special circumstance might be something like an instance within the route map which does not have a match statement and has only a set statement like this:

route-map korea 40

set ip precedence 32

in this case there is no statement to match and all set statements are executed.

Perhaps if you post the link to where you find this statement we can help find out whether there is some special circumstance it is discussing or whether it is an error in documentation.

HTH

Rick

3 REPLIES

Re: I have a question that How PBR works?

Hi,

It may be some mistyping.

If the packet does not match any route-map statements, then it is routed per the contents of the IP routing table.

In this specific case the packets are routed per the IP routing table when the packets match any route-map statement.

This is because you only set the IP precedence of the packets, and you do not set either the ip next-hop or the outgoing interface.

Cheers:

Istvan

New Member

Re: I have a question that How PBR works?

yes, You are right.

the packet is setted the ip precendence value and processing next destination by referencing normal ip routing table.

the most thing I wonder is..

the statnement from cco, What is mean like below?

If the packets do not match any route map statements, then all the set clauses are applied

Hall of Fame Super Silver

Re: I have a question that How PBR works?

Sung

The statement that you quote does not seem correct to me. I wonder if it is discussing some specific circumstance or perhaps is just an error in the documentation. A special circumstance might be something like an instance within the route map which does not have a match statement and has only a set statement like this:

route-map korea 40

set ip precedence 32

in this case there is no statement to match and all set statements are executed.

Perhaps if you post the link to where you find this statement we can help find out whether there is some special circumstance it is discussing or whether it is an error in documentation.

HTH

Rick

548
Views
0
Helpful
3
Replies
CreatePlease login to create content