Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

I need help Cisco 2600

Hello,

(i can?t speak english...)

I have the Cisco 2600 with a ISDN and a Analog Modul

A PC what have a ISDN Card i can connect to the Router an work in my Network.

With a PC what have a 56K Modem or a 28k Modem i can connect but not work. Everytime.. 1 / 2 Minutes i get a disconnect (No Massage)

I Have try to set the IDL Time higher.. and i have set the connecttime high.

..

I configurate the Router four Days now.. and now.. i give it up..

Pleas help me..

----------- the Config ----------

(I have the IP?s what have the same number marked with a "X" "Y" "Z"

I hope everybody can help me !! I want go back to my famely !!

5 REPLIES
Hall of Fame Super Silver

Re: I need help Cisco 2600

Kai

I have looked at the config that you posted and I believe that the problem is that there is not a dialer-group for the async interface to identify interesting traffic. With no interesting traffic the idle timer will run out and terminate the call. I suggest that you add dialer-group 1 under the async interface. Try it and let us know if it helps.

HTH

Rick

New Member

Re: I need help Cisco 2600

Hi,

thanks for your help.

my english is realy terrible.. :-)

pleas show my new config.

Than i have a connection txt where you can see that i can connect.

but i belive that (so i have see it by connect with ISDN) the call from my Client PC get no route to my network here. (peer)

I call the router with a 9,6 Kb Modem (Mobilephone) but i think that is not the problem. It have to worke!

Now i am 12 h here and i will crazy!! :-)

Thanks for Help

Kai

Hall of Fame Super Silver

Re: I need help Cisco 2600

Kai

Could you post the output of route print from the PC when it is dialed in?

HTH

Rick

New Member

Re: I need help Cisco 2600

Hey Rick,

i have no print when it is dialed in! But i have chang the text.. but i m not to 100 % sure!

I will drive to the other PC now and will be back in the next time!

Only for you :-) no..

my last hope your are

I hope the call with the ISDN PC will help us. But i m not sure that the ISDN Canal is free! But i try!!

Thanks so much

New Member

Re: I need help Cisco 2600

So,

i am back now!

It dont work!

I will hope.. i havn?t distroy the ISDN Parameter..

But, this isn t a problem now! I hope!

The PC called me a hardware error.. i hope the ISDN Card is dead!

Now i wait for a answer :-)

I can?t drive at home when it dosnt work! I will not drive the 800 km next week again!

Thanks

Kai

150
Views
5
Helpful
5
Replies
CreatePlease login to create content