Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

iBGP Multi-Link Question

I'm in a scenario where I have two routers, configured with two loopbacks, connected together via two links. I'm in the process of transitioning from one loopback to the other and I was wondering if there are any caveats to having two sessions up...one BGP session to the first lookback (existing), then another BGP session up to the second loopback (new).

I don't believe their should be any issues with this...and I don't see any documentation suggesting otherwise...just thought I'd ask to be certain :-)

ROUTER1============ROUTER2

Lo1:10.1.1.1/32 Lo1:10.1.2.1/32

Lo2:10.1.1.2/32 Lo2:10.1.2.2/32

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Silver

Re: iBGP Multi-Link Question

Hello Jeff,

I think you shouldn't have any problem in this migration to loop2 iBGP endpoints.

It should be better if iBGP next-hop = OSPF router-id it is more safe it will pass the sync test (if sync is not disabled).

Hope to help

Giuseppe

3 REPLIES
Hall of Fame Super Silver

Re: iBGP Multi-Link Question

Hello Jeff,

your understanding is correct: you can setup the second iBGP session that uses the loop2 on both routers.

Some issues can arise if redistributing ospf into/from BGP: it has been noticed that is necessary to have OSPF router-id = BGP router-id

If there isn't any redistribution of BGP or into BGP it should be a smooth transition.

Hope to help

Giuseppe

New Member

Re: iBGP Multi-Link Question

The OSPF router-ids were changed prior to this upcoming change...thus the router-ids will be the source loopbacks for BGP. No problems then? :)

THanks!

Hall of Fame Super Silver

Re: iBGP Multi-Link Question

Hello Jeff,

I think you shouldn't have any problem in this migration to loop2 iBGP endpoints.

It should be better if iBGP next-hop = OSPF router-id it is more safe it will pass the sync test (if sync is not disabled).

Hope to help

Giuseppe

124
Views
0
Helpful
3
Replies