cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
298
Views
0
Helpful
1
Replies

IGMP and conference call issue

trinawong
Level 1
Level 1

Dear All,

I have a customer reported that they have some problem for conference call, one to one call is O.K., however, when multiple user join conference call, it's getting problem, customer requested to enable IGMP on the router, could you please guide what's the good point here to enable IGMP? or any good documentation for IGMP and voice will be great!

Thank you so much.

1 Reply 1

Giuseppe Larosa
Hall of Fame
Hall of Fame

Hello Trina,

your customer thinks that the conference call being a multipoint service can be mapped over an IP multicast address.

If this is the case they are right but you may need to enable multicast routing on your router

ip multicast-routing

on each interface that can be source, destination or transit for multicast traffic

ip pim sparse-dense-mode

note: this will also enable igmp on lan interfaces automatically

for more info see

for an introduction to multicast see from 12.4 multicast conf guide:

http://www.cisco.com/en/US/docs/ios/ipmulti/configuration/guide/imc_basic_cfg_ps6350_TSD_Products_Configuration_Guide_Chapter.html

Hope to help

Giuseppe

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: