The error message "Invalid Login Attempt via Control Port", means exactly that. Someone or something has not enter the correct characters into the control port access interface to allow them access to the node. This could be a malicious attempt to access the node or it could be the control port is cabled to a terminal server which is outputting characters/echoing back towards the
control port. The node will by default output txt to the control port during boot so you can diagnose problems but it should not receive txt back when this is occuring as it can intterupt the boot cycle. If this happens during a switchcc you would need to check if there is terminal server or some other device connected to this interface and how its configured in comparison to
The NPM is connected to the URM Console port via the console cable. This is an ordinary implementation for remote management of URM's.We connect to NPM and then to URM with "window" command. Then come back to NPM with a command we choose with "CNFTERMFUNC" command.
I think there is a cable problem, because when we pull the cable of the system stops transmitting messages.
I also think that this messages, generatered by NPM, eventually causes to IGX reboot, considering these invalid logins as an attack.
Has it happened to you?
P.S. Can you post me your e-mail, because there are not many IGX experts around here.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...