I have configured all my dhcp, nat, and access lists but i cant figure out why i cannot connect to the host to get internet. Below is my sh ip route and sh ip int brief.
Gateway of last resort is 192.168.0.1 to network 0.0.0.0
S* 0.0.0.0/0 [1/0] via 192.168.0.1 is directly connected, FastEthernet0/0 192.168.0.0/24 is variably subnetted, 2 subnets, 2 masks C 192.168.0.0/24 is directly connected, FastEthernet0/0 L 192.168.0.6/32 is directly connected, FastEthernet0/0 192.168.2.0/24 is variably subnetted, 2 subnets, 2 masks C 192.168.2.0/24 is directly connected, FastEthernet0/1 L 192.168.2.1/32 is directly connected, FastEthernet0/1
Router#sh ip int bri Interface IP-Address OK? Method Status Protocol FastEthernet0/0 192.168.0.6 YES DHCP up up FastEthernet0/1 192.168.2.1 YES manual up up NVI0 192.168.0.6 YES unset up up
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.