image is having the "Legend " symbole attached -6500 switch
Hi Guys ,
I m finding the stable image for 6500 switch on cisco download s/w page .I found one of the image is having the "Legend " symbole attached to it in front .
It says this image has "elevated status designation from Cisco " Is this is the stable version of image and cisco recommands to upgrade this release .I do not have information on this , please put your comment on the same .
Below is the symbole and attached and info
The icon next to the release number indicates that a software image(s) under that release has received an elevated status designation from Cisco
If IOS version received Safe Habor designations, it means no major defects identified in tested areas.
"Regardless of the test results, a thorough bug scrub should be performed prior to every deployment. Also, a full review of the Safe Harbor documentation should be completed in order to identify gaps between what is tested in Safe Harbor and what is being planned for deployment. Any identified gaps should be tested by the customer and brought to the attention of the Safe Harbor team for possible inclusion in future test cycles." ---> from safe habor
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...