Implementing minimum and maximum threshold for WRED
I am trying to understand how to derive the correct minimum and maximum threshhold for LLQ. For example I have MLPPP with four T1 circuits. And I assign the following.
1 percent for class_cs6 10 percent for class-EF 70 percent for class-AF-41 10 percent for class-AF-31 9 percent fro default-class
I am also implementing WRED for classes cs6, 41,31 and default. How do I compute the minimum threshold so that packets will tail drop once it will exceed the bandwidth assigned. For example for default class I want WRED to start dropping packet once it reach 100Kbps and starts tail dropping when in exceeds138Kbps.
I know i can use the policy-route for that but is there a way to do it using WRED configuration?
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...