inbound NAT rule with port openings on router needed
Not sure where to start, I have 5 static IPs available on my inbound T1's, one is in use for the outbound nat overload pool. This site now is getting some ADT security cameras. They want some ports opened and a public and private address. Ports 8200, 8016, 10019, 8201 This is an 1841 router with ACL's applied on all the interfaces. How do I program this inbound NATing to go to the private IP with certain open ports?
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...