Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

Inconsistent Address & Mask P2P T1

I have a P2P T1 between locations, each router have two ethernet interfaces, one interface is configured for communitcations between locations for our phone system.  What I am trying to achive here is to use the second interface on each router for data traffic.  I have for the phones interface configured with IP's 10.x.x.x with static routes set which works without issue, now when I configure the second interface with IP's 172.x.x.x and attempt to create a static route from one side to the other i receive the following error "inconsistent address & mask" I have even attempted to change the subnet mask to another value without success.

Everyone's tags (5)
1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Inconsistent Address & Mask P2P T1

Stephen,

This looks like a typo in your ip route command. What exact network address and netmask are you using?

Best regards,

Peter

3 REPLIES
Cisco Employee

Inconsistent Address & Mask P2P T1

Stephen,

This looks like a typo in your ip route command. What exact network address and netmask are you using?

Best regards,

Peter

New Member

Inconsistent Address & Mask P2P T1

Peter you were right there was a typo, i was trying to route from IP to IP and used the subnet 255.255.255.0 instead of 255.255.255.255 this was the issue, my mistake was I wanted to create a static route from network to network and thus would use 255.255.255.0. 

Thank you,

Stephen

Hall of Fame Super Gold

Re: Inconsistent Address & Mask P2P T1

Stephen

There is not enough information here to allow us to determine what is the problem. Posting the specific static route would be a good start.

From the symptom my first guess would be that your route has a host specific address with a mask for a subnet. But without seeing the route specifics it is only a guess.

HTH

Rick

Sent from Cisco Technical Support iPad App

691
Views
5
Helpful
3
Replies
CreatePlease to create content