we have a catalyst 6504-E with SUP720 (IOS 12.2(18)SXF12a) switch with several L3 routed ports, I configured this ports to export netflow data to Orion Traffic Analyzer server but I can see only the egress traffic.
You can see the config below:
-- GLOBAL CONFIG --
mls flow ip full
mls nde sender version 5
ip flow-export source Loopback0
ip flow-export destination "IP ORION" 9996
-- ROUTED INTERFACE CONFIG --
ip flow ingress
ip route-cache flow
Do I miss something in the config? Why I cannot see the ingress traffic data on the configured interfaces?
This document gives several answers on frequently asked questions for PFRv3 channel state behavior.
Q1: What are all the channel operational states from a BR (border role) perspective and what are the rules/conditions to be in each st...
The need was to reach an host inside a LAN through a VPN connection managed by the LAN gateway (Cisco 1921).
The LAN gateway performs NAT and there was a dedicate nat rule for the host i wanted to reach through VPN.
I couldn't connect to the hos...
We have 3 identical switches configured by someone else and would like to claim some of the Gigabit ports(G1/G2/G3/G4) for use on servers. When we try to change the wiring and configuration, we run in to connectivity issues. Attached is a des...