Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Input queue size have negative figure

Hi,

I have a router work in tunnel. When I show interface tunnel, in the input queue, size have a negative figure. May I know why and how should I solve it. Below is one example.

Tunnel113 is up, line protocol is up

Hardware is Tunnel

Description: SJ to PG

Internet address is 192.168.252.138/24

MTU 1514 bytes, BW 9 Kbit, DLY 500000 usec,

reliability 255/255, txload 1/255, rxload 1/255

Encapsulation TUNNEL, loopback not set

Keepalive not set

Tunnel source 66.35.197.194 (FastEthernet0/0), destination 210.19.133.21

Tunnel protocol/transport GRE/IP, key disabled, sequencing disabled

Tunnel TTL 255

Checksumming of packets disabled, fast tunneling enabled

Last input 00:00:00, output 00:00:00, output hang never

Last clearing of "show interface" counters 00:50:42

Input queue: -995291044/75/0/0 (size/max/drops/flushes); Total output drops: 0

Queueing strategy: fifo

Output queue: 0/0 (size/max)

5 minute input rate 0 bits/sec, 0 packets/sec

5 minute output rate 0 bits/sec, 1 packets/sec

33251 packets input, 6865110 bytes, 0 no buffer

Received 0 broadcasts, 0 runts, 0 giants, 0 throttles

0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort

39546 packets output, 21799455 bytes, 0 underruns

0 output errors, 0 collisions, 0 interface resets

0 output buffer failures, 0 output buffers swapped out

3 REPLIES
New Member

Re: Input queue size have negative figure

The problem may be due to router running older version of IOS

New Member

Re: Input queue size have negative figure

New Member

Re: Input queue size have negative figure

198
Views
0
Helpful
3
Replies