Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

INSTALLATION OF CALLMANGER 5.1 IS ABORTED IN MCS7825-H2

WHEN I TRIED TO INSTALL THE CALLMANGER 5.1(1B) IN MCS 7825-H2 SERVER THE FOLLOWING ERROR OCCURED AND THE INSTALL ATION IS ABORTED.THE ERROR MESSAGE WAS...

CRITICAL ERROR

[create.sh]: hrconf create argument: 1 LOGICALDRIVE Init

A selected physical device is not available for use.

Could not open log file :UcliEvt.log

controllers found : 1

Command aborted.

[create.sh]:ERROR: Cannot create SATA RAID

Could not open log file :UcliEvt.log

controllers found : 1

---------------------------------------------------------------------------------------------------------------------------------------------------------

Controller Information

--------------------------------------------------------------------------------------------------------------------------------------------------------

Controller Status : OK

Channel Description : SATA

Defunct disk drive count : 0

Logical drivers/Failed/De.... : 0/0/0

Command completed successful

.AFTER THE ABOVE ERROR MESSAGE THE INSTALLATION WAS ABORTED.PLEASE FIND THE ERROR MESSAGE AND GIVE ME THE SOLUTION FOR THIS PROBLEM.

1 REPLY
Hall of Fame Super Silver

Re: INSTALLATION OF CALLMANGER 5.1 IS ABORTED IN MCS7825-H2

Hello Moncy,

post it under Unified Communications / IP Telephony where you can find better help

Hope to help

Giuseppe

233
Views
0
Helpful
1
Replies