I'm installing 2 T1 WICs w/ 2 ports each. I'm going to use 3 of the ports each with it's own T1 card. At the same time I'm going to drop the existing serial DS3 module in favor of these T1 WICs. So if this is the config. of the serial:
ip address 160.x.x.x 255.255.255.252
ip access-group 101 in
ip verify unicast reverse-path
no ip redirects
no ip unreachables
no ip proxy-arp
ip route-cache flow
dsu bandwidth 44210
no cdp enable
how do i go about getting the 3 WICs configured to use this IP and ACL. Do I need to bridge them? If so how?
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...