Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Installing VWIC2-1MFT-G703 in 2911 router

Hi,

I have to terminate an E1 using VWIC2-1MFT-G703 Interface card on 2911/k9 router but as per my knowledge installing HWIC card in EHWIC slot requires an intermediate jacket but I am not sure. I shall be grateful if someone can guide me a) is it is possible b) how?

2 ACCEPTED SOLUTIONS

Accepted Solutions
Hall of Fame Super Gold

Re: Installing VWIC2-1MFT-G703 in 2911 router

Nothing is needed to install this card.

Note, unless you must using unframed mode, the expensive -G703 version is not necessary.

Re: Installing VWIC2-1MFT-G703 in 2911 router

Hello!

A. Yes. EHWIC's  are of the exact same form factor as an HWIC. Hence any supported HWIC,  WIC, VIC or VWIC will seat in an EHIC without the use of an adapter  card.

https://www.cisco.com/en/US/prod/collateral/routers/ps10538/aag_c07_563807.pdf

In the PDF above you can see your card being supported by ISR G2 routers.

I hope this helps you!

Cheers,

Calin

6 REPLIES
Hall of Fame Super Gold

Re: Installing VWIC2-1MFT-G703 in 2911 router

Nothing is needed to install this card.

Note, unless you must using unframed mode, the expensive -G703 version is not necessary.

Community Member

Re: Installing VWIC2-1MFT-G703 in 2911 router

Thanks Paolo for your quick response and support.

Arshi

Hall of Fame Super Gold

Re: Installing VWIC2-1MFT-G703 in 2911 router

You are welcome, thanks for the nice rating and good luck!

Re: Installing VWIC2-1MFT-G703 in 2911 router

Hello!

A. Yes. EHWIC's  are of the exact same form factor as an HWIC. Hence any supported HWIC,  WIC, VIC or VWIC will seat in an EHIC without the use of an adapter  card.

https://www.cisco.com/en/US/prod/collateral/routers/ps10538/aag_c07_563807.pdf

In the PDF above you can see your card being supported by ISR G2 routers.

I hope this helps you!

Cheers,

Calin

Community Member

Re: Installing VWIC2-1MFT-G703 in 2911 router

Ddear Calin,

Thanks for your support, I have seen this document this morning but was not sure.

Thanks,

Arshi

Re: Installing VWIC2-1MFT-G703 in 2911 router

Thanks for rating, really appreciate it!

Good luck and I hope to see you on this board again!

Calin

1787
Views
5
Helpful
6
Replies
CreatePlease to create content