Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Integrated Routing and Bridging (IRB)

Hello,

I cannot assign a bridge group to a subinterface :

interface GigabitEthernet0/1/3

no ip address

negotiation auto

!

interface GigabitEthernet0/1/3.3

encapsulation dot1Q 3 native

*** bridge-group 3 is not recognized by IOS XE Version 15.1(3)S1

!

interface GigabitEthernet0/1/3.228

encapsulation dot1Q 228

*** bridge-group 228 is not recognized by IOS XE

!

interface BVI3

ip address x.x.3.1 255.255.255.0

!

interface BVI228

ip address x.x.228.1 255.255.252.0

!

bridge 3 protocol ieee

bridge 3 route ip

bridge 228 protocol ieee

bridge 228 route ip

It appears that the bridge-group command is not available.

Regards

3 REPLIES
VIP Super Bronze

Integrated Routing and Bridging (IRB)

Hi,

Have you tried the command under the interface and not sub-interface?

interface GigabitEthernet0/1/3

no ip address

negotiation auto

bridge-group 3

HTH

New Member

Integrated Routing and Bridging (IRB)

Hello,

yes i tried that because i read on a post that bridge-group should be set on the interface and sub-interface as well, but even on the interface the command is not available.

Regards.

New Member

Re: Integrated Routing and Bridging (IRB)

Hello,

Finally I was told that the "bridge-group" command in not yet available on IOS XE, and will be implemented in the next release. It is quite surprising.

Regards.

512
Views
0
Helpful
3
Replies