Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Inter vlan routing

I I'm trying to configure intervlan routing in a cisco 3560 switch but so far i was unable to suceed

can somebody give me some help

3 REPLIES
Hall of Fame Super Bronze

Re: Inter vlan routing

It's as simple as turning on ip routing in the global config (disabled by default).

I'm assuming you've configured workstations on each Vlan to point to the 3560 as the default gateway, correct ?

Let's see the show ip int bri | ex una as well as show ip route connected output.

Hall of Fame Super Silver

Re: Inter vlan routing

Artur

There are a couple of assumptions in Edison's answer and perhaps it would help to be explicit about them.

- are several VLANs properly configured?

- are some end stations connected in each VLAN?

- does each end station have an IP address in the correct subnet and is it configured with the 3560 as its default gateway?

- are VLAN interfaces configured for each VLAN? (note that configuring VLANs and configuring VLAN interfaces are diferent things)

If these assumptions are true then Edison's answer is correct that all you need to do is to configure "ip routing".

HTH

Rick

Highlighted

Re: Inter vlan routing

Errr, I might be repeating above to answers.

but this is how I usually do it.

1- configure VLAN (conf t ==> VLAN100).

2-assign port to VLAN ( either access or trunk).

3-create SVI ( Conf t ==> int VLAN 100).

4- unshut or admin up int VLAN 100.

5-ur host should be able to ping Gateway , ie int VLAN address.

repeat same for second VLAN.

If Host A & B can ping their respective GTWs, then they will ping each other. so u have inter-vlan routing.

HTH

Sam

210
Views
0
Helpful
3
Replies
CreatePlease login to create content