Interested Traffic ACL in Tunnel Protection Config

[snarayanaraju]

Hi Experts - Generally I configure IPSEC Site-Site VPN using Crypto map, defining the peer and match address (ACL for Interested Traffic) and finally binding the Crypto-map in the Tunnel or Interface

Now, i am configuring the IPSEC site-site VPN using Tunnel mode Protection method, where and how to define the Interested Traffic so that I can have control which traffic should be encrypted and plain traffic without encryption

Thanks in advance

sairam

[Joseph W. Doherty]

Disclaimer

The Author of this posting offers the information contained within this posting without consideration and with the reader's understanding that there's no implied or expressed suitability or fitness for any purpose. Information provided is for informational purposes only and should not be construed as rendering professional advice of any kind. Usage of this posting's information is solely at reader's own risk.

Liability Disclaimer

In no event shall Author be liable for any damages whatsoever (including, without limitation, damages for loss of use, data or profit) arising out of the use or inability to use the posting's information even if Author has been advised of the possibility of such damage.

Posting

VTI encrypts whatever traffic transits the tunnel.  You determine what traffic you want to transit the tunnel, "normally".  If you don't want traffic to be encrypted, either send it to the physical interface, or use a different tunnel (e.g. GRE).

[snarayanaraju]

Thank you. Sounds logical. I will go ahead with this approach. Thanks again

regards SAIRAM