Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

interface counters

silly question, however I can't find documentation to back it up. should inerrors = the sum of controller errors + interface errors ?

2 REPLIES

Re: interface counters

Hi,

Input error :

Includes runts, giants, no buffer, CRC, frame, overrun, and ignored counts. Other input-related errors can also cause the input errors count to be increased, and some datagrams may have more than one error; therefore, this sum may not balance with the sum of enumerated input error counts.

Please read this.

http://www.cisco.com/univercd/cc/td/doc/product/software/ios121/121cgcr/inter_r/irdshoin.htm#1017387

HTH, Please rate if it does.

-amit singh

Re: interface counters

Hi

Though i am not sure about which interface you are talking about hope this link will help u out understand the following errors and the possible reasons for the same..

1)Increasing Output Drops on Serial Link

2)Increasing Input Drops on Serial Link

3)Increasing Input Errors in Excess of One Percent of Total Interface Traffic

4)Troubleshooting Serial Line Input Errors

5)Increasing Interface Resets on Serial Link

6)Increasing Carrier Transitions Count on Serial Link

http://www.cisco.com/en/US/tech/tk713/tk628/technologies_tech_note09186a00800a758d.shtml

regds

114
Views
7
Helpful
2
Replies
CreatePlease to create content