Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Interface Dialer Bandwidth with ATM Interface

Hi,

I would like to know how to automatically have correct bandwidth under my Dialer Interface who is attached to an ATM Interface.

Command bandwidth inherit doesn't work.

=>

interface ATM0

no ip address

no ip route-cache cef

no ip route-cache

no atm ilmi-keepalive

dsl operating-mode itu-dmt

pvc 8/35

encapsulation aal5mux ppp dialer

dialer pool-member 1

!

end

interface Dialer1

bandwidth inherit

ip address negotiated

sh int atm 0

ATM0 is up, line protocol is up

Hardware is DSLSAR (with Alcatel ADSL Module)

MTU 4470 bytes, sub MTU 4470, BW 928 Kbit, DLY 2200 usec,

sh int di 1

Dialer1 is up, line protocol is up (spoofing)

Hardware is Unknown

MTU 1500 bytes, BW 56 Kbit, DLY 20000 usec,

Bandwidth under dialer is still 56Kbit and under ATM 0 928 Kbit !!!

Thanks

5 REPLIES
Hall of Fame Super Gold

Re: Interface Dialer Bandwidth with ATM Interface

Check virtual-access interfaces.

New Member

Re: Interface Dialer Bandwidth with ATM Interface

Yes, interface virtual access 2 got the right bandwidth.

But I have CBWFQ applied under dialer 1 interface so I need to have the right bandwidth for this interface for CBWFQ !

Hall of Fame Super Gold

Re: Interface Dialer Bandwidth with ATM Interface

Since VA inherits all configuration from dialer, everything will work as supposed.

Please remember to rate useful posts with the scrollbox below.

New Member

Re: Interface Dialer Bandwidth with ATM Interface

Sorry but VA inherit everything but queueing strategy, I've got Dialer 1 with Class-based queueing and VA2 with fifo queueing ?

At least, my question is : is there a command to have bandwidth under dialer1 automatically equal to atm bandwidth ???

Hall of Fame Super Gold

Re: Interface Dialer Bandwidth with ATM Interface

That could happen because the default PVC traffic category (UBR) does not allow QoS.

Beside that, it is working as designed, nothing will ever change any configuration under dialer.

2257
Views
0
Helpful
5
Replies