Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Interface error

Please what is the possible cause and solution of this interface error.

BB1#show int fa0/1

FastEthernet0/1 is up, line protocol is up

  Hardware is Gt96k FE, address is 0007.0e3c.f957 (bia 0007.0e3c.f957)

  Description: *****WAN CONNECTION *****

  Internet address is xx.xx.xx.xx/29

  MTU 1500 bytes, BW 100000 Kbit/sec, DLY 100 usec,

     reliability 255/255, txload 1/255, rxload 1/255

  Encapsulation ARPA, loopback not set

  Keepalive set (10 sec)

  Full-duplex, 100Mb/s, 100BaseTX/FX

  ARP type: ARPA, ARP Timeout 04:00:00

  Last input 00:00:00, output 00:00:00, output hang never

  Last clearing of "show interface" counters never

  Input queue: 0/75/4/0 (size/max/drops/flushes); Total output drops: 0

  Queueing strategy: fifo

  Output queue: 0/40 (size/max)

  5 minute input rate 277000 bits/sec, 120 packets/sec

  5 minute output rate 149000 bits/sec, 140 packets/sec

     2615122 packets input, 739484174 bytes

     Received 957 broadcasts, 246 runts, 0 giants, 0 throttles

     5994 input errors, 5994 CRC, 0 frame, 0 overrun, 0 ignored

     0 watchdog

     0 input packets with dribble condition detected

     2843074 packets output, 371490795 bytes, 0 underruns

     0 output errors, 0 collisions, 3 interface resets

     0 unknown protocol drops

     0 babbles, 0 late collision, 0 deferred

     0 lost carrier, 0 no carrier

     0 output buffer failures, 0 output buffers swapped out

3 REPLIES
Hall of Fame Super Bronze

Re: Interface error

Hall of Fame Super Gold

Re: Interface error

The command "sh controller ethernet F0/1" will give you a detailed information about the line errors.

Hall of Fame Super Gold

Re: Interface error

Chances are, the other device is set to half-duplex.

325
Views
0
Helpful
3
Replies