Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

interface f0/0 up and down

Hi all,

I have a problem with my interface e0/1 in a 2650 it?s been up and down for more than one month now. I've changed the router supposing, it?s an Ethernet problem as well as the cable from sw2, and this router offers static IP translation between 10.1.0.0/24 subnet and 192.168.0.0/24 subnet. It doesn?t know if it?s the configuration is causing this problem; I've attached a copy of the configuration and a diagram of my network connectivity.

3 REPLIES

Re: interface f0/0 up and down

Hi,

I see from the diagram that there is a switch (SW1) between Router 2650XM and SW2.

Try hard-coding the speed and duplex to 100BaseT/Full-dupex both Router 2650XM F0/1 and SW1 FE port connecting to Router 2650XM

Dandy

New Member

Re: interface f0/0 up and down

Hi

Actually u r n need to translate the 10.x.x.x segment to 192.168 or the reverse? Becos according to the config the 192.168 will be translated into 10.x. If the traffic is in the reverse direction then you may have to change the format a little

New Member

Re: interface f0/0 up and down

Change the speed and duplex on both ends of the problem interface to be the same, preferably 100/full.

Let us know if it works.

146
Views
0
Helpful
3
Replies