Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

interface hold-queue, QoS question

If I have a serial interface configured per below, is the hold-queue doing anything?

My understanding is hold-queue is a fifo function and by applying the QoS policy aren't I using CBWFQ in the interface?

policy-map P-QoS

class VOICE

priority 256

set dscp ef

class DATA-Priority

bandwidth 128

set dscp af31

class class-default

set dscp default

fair-queue

random-detect

map-class frame-relay P-class

frame-relay cir 1536000

service-policy output P-QoS

interface Serial0/1/0

bandwidth 1536

no ip address

encapsulation frame-relay IETF

no fair-queue

frame-relay traffic-shaping

frame-relay lmi-type cisco

hold-queue 256 in

hold-queue 256 out

!

interface Serial0/1/0.400 point-to-point

ip address 1.2.1.54 255.255.255.252

ip nbar protocol-discovery

ip flow ingress

ip flow egress

frame-relay interface-dlci 400 IETF

class P-class

crypto map P_Crypt

2 REPLIES
Hall of Fame Super Silver

Re: interface hold-queue, QoS question

Hello Richard,

hold-queues are used for process-switched traffic like routing protocols hellos and updates.

QoS applies to user traffic

It shouldn't be a problem.

Hope to help

Giuseppe

New Member

Re: interface hold-queue, QoS question

Is there any reason to change these parameters from the default?

Also on the interface is:

"no fair-queue"

If I have a qos policy aren't I using CBWFQ?

How would this be affecting the policy applied to the sub-interface?

875
Views
0
Helpful
2
Replies