Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Interface Queueing

What causes the following: And is this an issue when seen on an interface?

Queueing strategy: weighted fair [suspended, using FIFO]

1 REPLY

Re: Interface Queueing

This is normally seen when the interface in questions is part of a bundle like the multilink

In these cases the WFQ is applied on the multilink interface and the serial interfaces would show as being suspended and using FIFO as id does nto make sense to have them go through the queueing again

HTH

Narayan

253
Views
4
Helpful
1
Replies
CreatePlease to create content