Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Interface State

Does anyone know why the interface is showing "reset" for layer 1 on a serial interface? I have removed the interface from the T1 controller and setup the interface again and have no cable plugged into the port, yet the device still states layer 1 is in "reset" indefinitely.

2 REPLIES
Blue

Re: Interface State

can you post the output of a show interface fo rthat interface?

Victor

New Member

Re: Interface State

#sh int s2/0:0

Serial2/0:0 is reset, line protocol is down

Hardware is M32X with CSU/DSU

MTU 1500 bytes, BW 1536 Kbit, DLY 20000usec,

reliability 255/255, txload 1/255, rxload 1/255

Encapsulation HDLC, loopback not set

Keepalive set (10 sec)

Last input never, output never, output hang never

Last clearing of "show interface" counters 11:35:22

Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0

Queueing strategy: weighted fair

Output queue: 0/1000/64/0 (size/max total/threshold/drops)

Conversations 0/0/256 (active/max active/max total)

Reserved Conversations 0/0 (allocated/max allocated)

Available Bandwidth 1152 kilobits/sec

5 minute input rate 0 bits/sec, 0 packets/sec

5 minute output rate 0 bits/sec, 0 packets/sec

0 packets input, 0 bytes, 0 no buffer

Received 0 broadcasts, 0 runts, 0 giants, 0 throttles

0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort

0 packets output, 0 bytes, 0 underruns

0 output errors, 0 collisions, 3 interface resets

0 output buffer failures, 0 output buffers swapped out

0 carrier transitions

Timeslot(s) Used:1-24, Transmitter delay is 0 flags

120
Views
0
Helpful
2
Replies
CreatePlease to create content