hi can any one please advice me how to configure a cisco 1841 router with ADSL port , i dont find any articles related to it,I have ADSL internet , can anyone please send me articles or advice regarding this, thanks in advance
m went through the configuration,i jst cant apply the dialer pool-member 1 command under atm interface, SHALL I have to use transmit-interface dialer 1 instead?also is it not required to enable pppoe under atm,if so ,how shall i?please advice me
am sorry,am a little bit confused regarding the encapsulation used ,if its PPPoA or PPPoE,incase if its PPPoA ,i think its fine,can u explain the command "encapsulation aal5mux ppp dialer" under ATM interface
also am not able to create vlan interface using interface vlan1,shall i have to use Bridged virtual interface instead??
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...