Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Internet lease line load balancing

i have one internet router connected with 2 lease lines with the same provider where i want to do load balancing, somebody help me what could be the simle configurations, or in this case Multilinking is a good solution

Zahid fayyaz

4 REPLIES

Re: Internet lease line load balancing

Hi,

You can use OSPF or BGP. We can throw a lot of suggestions to you but it depends what is permitted by your ISP, talk to them about your objective.

Regards,

Dandy

Re: Internet lease line load balancing

duh, double post

Hall of Fame Super Silver

Re: Internet lease line load balancing

Zahid

The suggestion by Dandy is a good one. Your ISP can tell you what they are willing to do and may very well have a suggestion of what they think is best.

My suggestion would be that if the ISP will support multilink over these 2 circuits that there would be some advantage in using multilink. And if multilink is not used I would suggest that the most simple solution for you would be to configure 2 default static routes with a default static route pointing out each of the leased line interfaces. This would provide redundancy and load sharing on both links and it minimizes the overhead processing on your router.

HTH

Rick

New Member

Re: Internet lease line load balancing

Thanks Forum i ll check with my service provider and get back soon

175
Views
0
Helpful
4
Replies