Question for you guys, it seems simple but I must be missing something
1. 1 Cisco 3600 Router
2. Int fa0/0 is for the Internet
3. Int fa0/1 is for the LAN
4. fa0/0 is for the WAN connection going into the firewall
5. fa0/1 is going into a 3750 switch
6. The LAN port of the firewall is connect to g1/0/3 of the 3750 in VLAN30
Right now all is working ok. Users able to browse the internet but I am unable to ping the IP of VLAN1 on the 3750. On the 3750 I set up a VLAN 30 which is for my primary ISP. From the 3600 fa0/1 is plugged into g1/0/2 of the 3750 on VLAN30. If I do a CDP nei I can see the router but cannot ping it even though it is on the same subnet.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...