guys i have cisco 2620 router with 16MB flash and 64 MB RAM.........now ihave put cisco NM 2V and VIV 2fxs card......i want to simulate alanloge calls between two routers (the other one is 2811) so can some one please advise me what would be the best IOS i shd download keeping in mind my hardware config for 2620......cheers an dthanks in advance
I have checked sifferent images for your router and most of them seems to have the requirement for 64MB Dram and 16MB flash, which inturn matches with your router. You maximum can get is the 12.3 IOS release for your router.You can download c2600-j1s3-mz.12.3-22.bin for your router.
My suggestion for your will be to go to the feature navigator and look the IOS and the featureset supported.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...