IOS HTTP Client URI lenght limit of 64 characters?
I am trying to use EEM to send a HTTP request based on an event (I am just trying with a copy http://xxx null:). I have the guts of this working (i.e. the event happens and the action is triggered etc) however the URL is quite long - it is 103 characters and there seems to be a limit of 64-characters. From the CLI if I simply type the copy command it is accepted and the router receives a response, however the whole of the URL was not sent - it ignores any characters after the 64th.
I have tried this on a Catalyst 3560G switch running IOS 15.0(1)SE3 and a 877 running IOS 15.1.(4)M4.
Is this a limitation of the copying command I am attempting or is it just a hard limit of the HTTP client?
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...