Hello
I have installed an ATM module (NM-1A-OC3SMI) in a 3745 router with IP Base image. Since the module was not supported, i upgraded to IP Plus image "c3745-is-mz.123-16.bin" as per software advisor. Still the module is under unknown for the router. Anyone can help?
Another question is that the show version shows that ROM has the IPBASE image and the system boot image is the flash one, the IP Plus image; does this relates somehow. The configuration register value should boot from flash
#sh ver
Cisco Internetwork Operating System Software
IOS (tm) 3700 Software (C3745-IS-M), Version 12.3(16), RELEASE SOFTWARE
(fc4)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2005 by cisco Systems, Inc.
Compiled Tue 23-Aug-05 16:46 by ssearch
Image text-base: 0x60008AF4, data-base: 0x61C40000
ROM: System Bootstrap, Version 12.3(6r) [cmong 6r], RELEASE SOFTWARE (fc1)
ROM: 3700 Software (C3745-IPBASE-M), Version 12.3(9e), RELEASE SOFTWARE
(fc1)
Router uptime is 6 minutes
System returned to ROM by reload
System image file is "flash:c3745-is-mz.123-16.bin"
cisco 3745 (R7000) processor (revision 2.0) with 250880K/11264K bytes of
memory.
Processor board ID FCZ094571XZ
R7000 CPU at 350MHz, Implementation 39, Rev 3.3, 256KB L2, 2048KB L3 Cache
Bridging software.
X.25 software, Version 3.0.0.
SuperLAT software (copyright 1990 by Meridian Technology Corp).
2 FastEthernet/IEEE 802.3 interface(s)
DRAM configuration is 64 bits wide with parity disabled.
151K bytes of non-volatile configuration memory.
31744K bytes of ATA System CompactFlash (Read/Write)
Configuration register is 0x2102
thank you
