Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

IOS router source NAT for a unconnected network

Hi

Would want to inside  source NAT an IP address which is not direclty attached to the NAT  inside interface ,,,it is a hop away from the inside interface...Appreciate pointers!

  • WAN Routing and Switching
2 ACCEPTED SOLUTIONS

Accepted Solutions

Re: IOS router source NAT for a unconnected network

Just configure as if the host were in the same subnet as one of the interfaces. Ip nat inside on the interface closest to the host.

Sent from Cisco Technical Support iPad App

Purple

IOS router source NAT for a unconnected network

Hi,

2points:

1) permit this subnet in your NAT ACL

2) make sure the router doing NAT has a route for this subnet.

Regards

Alain

Don't forget to rate helpful posts.

Don't forget to rate helpful posts.
2 REPLIES

Re: IOS router source NAT for a unconnected network

Just configure as if the host were in the same subnet as one of the interfaces. Ip nat inside on the interface closest to the host.

Sent from Cisco Technical Support iPad App

Purple

IOS router source NAT for a unconnected network

Hi,

2points:

1) permit this subnet in your NAT ACL

2) make sure the router doing NAT has a route for this subnet.

Regards

Alain

Don't forget to rate helpful posts.

Don't forget to rate helpful posts.
144
Views
0
Helpful
2
Replies
This widget could not be displayed.