Does IOS XE not support debugging of received packets with the "debug ip packet" output? I have a case where the router only shows locally generated packets in "debug ip packet [detail]" output, but nothing that is being received. This is both for data plane, e.g. ICMP echo, and for control plane, e.g. EIGRP or OSPF hellos. I tried disabling CEF as well but it's not supported on this platform:
Router(config)#no ip cef distributed
%Cannot disable CEF on this platform
Router(config-if)#no ip route-cache Platform cannot disable ip route-cache on GigabitEthernet1 interface
I am not sure about the Platform you are using, however i've seen similar issues with ASRs. We had to apply an Access-list with a log keyword at the end of it to make sure that the packets are hitting the CPU and it does show up in the debugs.
ip access-list extended TEST
permit ip any any log
However just a Heads up if you do want to try this please make sure that the traffic is not so much on the interface as this will cause almost all the packets to be CPU switched. Maybe you can apply this log keyword to some specific statement in the ACL if you know the source and destination IP address of the traffic that you want to see.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...