Does IOS XE not support debugging of received packets with the "debug ip packet" output? I have a case where the router only shows locally generated packets in "debug ip packet [detail]" output, but nothing that is being received. This is both for data plane, e.g. ICMP echo, and for control plane, e.g. EIGRP or OSPF hellos. I tried disabling CEF as well but it's not supported on this platform:
Router(config)#no ip cef distributed
%Cannot disable CEF on this platform
Router(config-if)#no ip route-cache Platform cannot disable ip route-cache on GigabitEthernet1 interface
I am not sure about the Platform you are using, however i've seen similar issues with ASRs. We had to apply an Access-list with a log keyword at the end of it to make sure that the packets are hitting the CPU and it does show up in the debugs.
ip access-list extended TEST
permit ip any any log
However just a Heads up if you do want to try this please make sure that the traffic is not so much on the interface as this will cause almost all the packets to be CPU switched. Maybe you can apply this log keyword to some specific statement in the ACL if you know the source and destination IP address of the traffic that you want to see.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.