Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

IOS XE Router and NAT

We migrated our IPSec Site To Site VPN configuration from a 3900 series IOS router to AS1006 IOS XE router.  Everything is working fine except NAT.  When I issue the command "show ip nat translation" I received the follow error message..

rtr01-edg1#show nat translation
%NAT64: feature not configured

Having looked up the error, I found that this command is necessary to enable NAT64: " nat64 enable".  From quick reading about this command I understand it is required for enabling IPv6 to IPv4 translation but I want to understand is is this required to enable regular NAT on this type of router?

 

Adil

157
Views
0
Helpful
0
Replies