Did you have to pick the one answer to mark as correct in our thread where i made a total idiot of myself
Seriously though, IOS XR is used on Cisco's high end platforms, namely the CRS, XR and ASR9000 platforms. I have never used it as i have never been lucky enough to get my hands on any of those platforms.
Not sure what you mean about it being specific to service providers but i suspect it is mainly service provider and very large Enterprises that use them.
If you are well versed on IOS platform then there is not much difference in IOS-XR for all the things you have been doing it, "?" will help you do anything. I reffered to this doc by cisco to understand the difference, it may confuse you at some point but just take a look.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...