Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

IOS

I'm trying to setup a test bed for callmanager 7 and the router I'm using for the network will not recognize any of the voice cards in the running config (as in, no dial-peers or voice ports.) I am running it's default IOS 12.4(3g) SPServices which we are using elsewhere just fine. I issue the "sh ver" command and I see that it recognizes that I have a 4 port FXO, 2-port FXS and a Channelized T1/PRI Controller card plugged in.

Sh Ver:

Cisco 2811 (revision 53.51) with 251904K/10240K bytes of memory.

Processor board ID FTX1233A42P

2 FastEthernet interfaces

1 Serial interface

1 Channelized T1/PRI port

4 Voice FXO interfaces

2 Voice FXS interfaces

DRAM configuration is 64 bits wide with parity enabled.

239K bytes of non-volatile configuration memory.

62720K bytes of ATA CompactFlash (Read/Write)

Any ideas would be greatly appreciated!

5 REPLIES

Re: IOS

Justin,

Please post a "sh diag" command.

To make sure that you have any PVDM installed on it.

Toshi

New Member

Re: IOS

Test_Router#sh diag

Slot 0:

C2811 Motherboard with 2FE and integrated VPN Port adapter, 2 ports

Port adapter is analyzed

Port adapter insertion time unknown

EEPROM contents at hardware discovery:

PCB Serial Number : FOC12312FZM

Hardware Revision : 1.0

Top Assy. Part Number : 800-26920-04

Board Revision : A0

Deviation Number : 0

Fab Version : 04

RMA Test History : 00

RMA Number : 0-0-0-0

RMA History : 00

Processor type : 87

Hardware date code : 20080731

Chassis Serial Number : FTX1233A42P

Chassis MAC Address : 0022.904c.9748

MAC Address block size : 24

CLEI Code : COM7R00ARA

Product (FRU) Number : CISCO2811

Part Number : 73-10258-05

Version Identifier : V05

EEPROM format version 4

EEPROM contents (hex):

0x00: 04 FF C1 8B 46 4F 43 31 32 33 31 32 46 5A 4D 40

0x10: 03 E7 41 01 00 C0 46 03 20 00 69 28 04 42 41 30

0x20: 88 00 00 00 00 02 04 03 00 81 00 00 00 00 04 00

0x30: 09 87 83 01 32 68 5B C2 8B 46 54 58 31 32 33 33

0x40: 41 34 32 50 C3 06 00 22 90 4C 97 48 43 00 18 C6

0x50: 8A 43 4F 4D 37 52 30 30 41 52 41 CB 8F 43 49 53

0x60: 43 4F 32 38 31 31 20 20 20 20 20 20 82 49 28 12

0x70: 05 89 56 30 35 20 D9 02 40 C1 FF FF FF FF FF FF

WIC Slot 0:

2nd generation - FXS Voice daughter card (2 port)

Hardware Revision : 3.1

Top Assy. Part Number : 800-21341-01

Board Revision : E0

Deviation Number : 0-0

Fab Version : 01

PCB Serial Number : FOC093352D2

RMA Test History : 00

RMA Number : 0-0-0-0

RMA History : 00

Version Identifier : V

Product (FRU) Number : VIC2-2FXS=

EEPROM format version 4

EEPROM contents (hex):

0x00: 04 FF 40 00 47 41 03 01 C0 46 03 20 00 53 5D 01

0x10: 42 45 30 80 00 00 00 00 02 01 C1 8B 46 4F 43 30

0x20: 39 33 33 35 32 44 32 03 00 81 00 00 00 00 04 00

0x30: 89 56 00 00 00 FF FF FF FF FF FF FF FF FF FF FF

0x40: FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF

0x50: FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF

0x60: FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF

0x70: FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF

WIC Slot 1:

2nd generation - FXO Voice daughter card (4 port)

Hardware Revision : 5.0

Top Assy. Part Number : 800-21589-02

Board Revision : A0

Deviation Number : 0-0

Fab Version : 04

PCB Serial Number : FOC10440M4U

RMA Test History : 00

RMA Number : 0-0-0-0

RMA History : 00

Product (FRU) Number : VIC2-4FXO

Version Identifier : V01

CLEI Code : CNUIAPRAAA

EEPROM format version 4

EEPROM contents (hex):

0x00: 04 FF 40 00 4C 41 05 00 C0 46 03 20 00 54 55 02

0x10: 42 41 30 80 00 00 00 00 02 04 C1 8B 46 4F 43 31

0x20: 30 34 34 30 4D 34 55 03 00 81 00 00 00 00 04 00

0x30: CB 89 56 49 43 32 2D 34 46 58 4F 89 56 30 31 20

0x40: C6 8A 43 4E 55 49 41 50 52 41 41 41 FF FF FF FF

0x50: FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF

0x60: FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF

0x70: FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF

New Member

Re: IOS

WIC Slot 2:

FT1 PMC4351

Hardware Revision : 1.2

PCB Serial Number : FOC10505GXJ

Part Number : 73-8346-05

Board Revision : A0

RMA Test History : 00

RMA Number : 0-0-0-0

RMA History : 00

Deviation Number : 0-0

Product (FRU) Number : WIC-1DSU-T1-V2

Top Assy. Part Number : 800-22193-03

CLEI Code : IPUIAPRRAA

EEPROM format version 4

EEPROM contents (hex):

0x00: 04 FF 40 00 52 41 01 02 C1 8B 46 4F 43 31 30 35

0x10: 30 35 47 58 4A 82 49 20 9A 05 42 41 30 03 00 81

0x20: 00 00 00 00 04 00 80 00 00 00 00 CB 94 57 49 43

0x30: 2D 31 44 53 55 2D 54 31 2D 56 32 20 20 20 20 20

0x40: 20 C0 46 03 20 00 56 B1 03 C6 8A 49 50 55 49 41

0x50: 50 52 52 41 41 FF FF FF FF FF FF FF FF FF FF FF

0x60: FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF

0x70: FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF

WIC Slot 3:

T1 (1 port) Multi-Flex Trunk WAN daughter card

Hardware revision 1.0 Board revision D0

Serial number 30264715 Part number 800-03568-03

FRU Part Number VWIC-1MFT-T1=

Test history 0x0 RMA number 00-00-00

Connector type PCI

EEPROM format version 1

EEPROM contents (hex):

0x20: 01 20 01 00 01 CD CD 8B 50 0D F0 03 00 00 00 00

0x30: 68 00 00 00 03 04 01 00 FF FF FF FF FF FF FF FF

Re: IOS

Justin,

You need PVDM installed on it.

Do you have a CCO ID? If you do, please check this link.

http://www.cisco.com/cgi-bin/Support/DSP/cisco_prodsel.pl

HTH,

Toshi

New Member

Re: IOS

I feel partially dumb, ha. Thanks for your help.

102
Views
5
Helpful
5
Replies