Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

IP addressing question

 

I have a Network - 192.168.1.1/24. The range is fully utilized (all IP addresses are already assigned to hosts). How can I add 10 more hosts without changing the address or mask. 

Thanks, 

Manu

2 REPLIES
Hall of Fame Super Gold

You configure secondary IP

You configure secondary IP address on the same VLAN.  

 

The command is "ip address 1.2.3.4 255.255.255.0 secondary".

Hello Manu,as you already

Hello Manu,

as you already have utilized the IPs from the range you have to go for an other subnet, so as said by Leo Laohoo you must configure the secondary IP on the interface and then you can utilize the range for the hosts.

Regards Thanveer "Everybody is genius. But if you judge a fish by its ability to climb a tree, it will live its whole life believing that it is a stupid."
23
Views
0
Helpful
2
Replies