Where to config ip bandwidth-percent eigrp, is it in the physical interface or in the interface tunnel. We have dmvpn design with 2 isp as hub router and 15 spokes. i am confused on the tunnel interface of the dmvpn. what is the best practice? pls help.
That goes to the tunnel interface. The best practice is to configure bandwidth statement on tunnel interface that reflects the physical interface bandwidth; otherwise the tunnel interface will use the default bandwidth value, which might cause issue for EIGRP route update message.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...