i have a point to point leased line of 2 mbps connected with 2503 at both ends. i have a video streaming server which send multicast at 22.214.171.124 and i want to receive it at the other end. how do enable the routers to do that.
If your multicast receivers (clients) are not capable of generating IGMP Membershit Report (asa IGMP Join) messages or there are no clients at all, you can use "ip igmp join-group" command to get multicast traffic forwarded to the router. This command should be applied to the LAN interface of the router in question.
If you use spare-mode it will cause the router to generate (*,G) PIM Join messages towards the RP.
Other alternative is to use "ip igmp static-group" command, which in essense does the same, but your multicast traffic will be fast switched (and not process switched) and you will not be able to ping the group address (with igmp join-group command you will).
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.