Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

ip nat inside source static: lan user unable to access server

I am using a cisco 1841 router and after I did an static translation on my router the lan users can no longer access the server. See below:

ip nat inside source static tcp 10.1.4.15 80 12.xxx.xxx.xxx 80 extendable

ip nat inside source static tcp 10.1.4.15 443 12.xxx.xxx.xxx 443 extendable

I am able to ping the WAN and LAN addresses used in the static map but the local users can't access the site. Any suggestions?

  • WAN Routing and Switching
2 REPLIES
Silver

Re: ip nat inside source static: lan user unable to access serve

Your commands are absolutely fine and it should work well. Just want to ask one question had entered the

ip nat inside

ip nat outside

comamnds

regards

shivlu

Re: ip nat inside source static: lan user unable to access serve

Hi,

Local users has nothing to do with your nat mappings.

Thoses mappings are required for external access purposes.

Your Lan users should be able to access the site if they within the Lan subnet. Other than that , check if you have any filtering done could eleminate Lan users from accessig a direct web-server.

HTH

Mohamed

118
Views
0
Helpful
2
Replies
This widget could not be displayed.