Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

ip nat over two pvc with cisco 876w

Hello,

I will connect my provider over 2 pvi.

I create two dialer. Each dialer gets a dynamic ip from my provider.

I would like to route all packages from 172.16.1.0 to dialer 1 and all packages from 172.16.2.0 to dialer 2.

I have create the following setup see attachment. I can route from 172.16.1.0 to dialer 1 but not form the second network two the second dialer. Can someone give me assistance?

with best regards

André

  • WAN Routing and Switching
1 REPLY
Hall of Fame Super Bronze

Re: ip nat over two pvc with cisco 876w

Remove the highlighted portion of the config:

route-map NAT-VoipDailer permit 10

description NAT route-map for dialer 2

match ip address ACL-NAT-VoipNet

match interface Dialer2

route-map NAT-DataDailer permit 10

description NAT route-map for dailer 1

match ip address ACL-NAT-DataNet

match interface Dialer1

and modify the following entry:

ip access-list extended PBR-Traffic-Divert

permit tcp 172.16.2.0 0.0.0.255 any

with:

ip access-list extended PBR-Traffic-Divert

permit ip 172.16.2.0 0.0.0.255 any

HTH,

__

Edison.

104
Views
0
Helpful
1
Replies