Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

IP Phones

Hi,

I have connected any IP phone to switch and PC to phone, and specify the voice VLAN and data VLAN seperately.

Is there any other command required in order to get the devices get an IP address from the exact VLANS( Voice and Data).

Thanks

Eldo

4 REPLIES
Hall of Fame Super Gold

Re: IP Phones

No other commands needed, of course you need a seperate dhcp servers for data and voice. The latter is usually CM or CME.

Hope this helps, please rate post if it does!

New Member

Re: IP Phones

Is it possible to do it with a single DHCP server.

Re: IP Phones

Hi

U can do it but its better to have the dhcp scopes on the CM for IP phones as it acts as tftp server also and ip phones needs some tftp options.

For data u can use the other server.

Thanks

Mahmood

Re: IP Phones

Hi

Ensure that u have configured spanning-tree porfast and u have the respective dchp scopes configured.

Thanks

Mahmood

123
Views
0
Helpful
4
Replies
CreatePlease to create content